Hi,

 

This issue can occur if a problem occurred within the Ntfs.sys file. The Ntfs.sys file is the driver file that enables your computer to read and write to NTFS partitions. Damage in the NTFS file system, damaged portions of your hard disk, or damaged SCSI or IDE drivers can also cause this issue.
Method 1: Start your computer in Safe Mode and perform Disk Check.
Step 1: Boot your computer in Safe mode
Step 2: To perform Disk Check, follow these steps:
a.Click Start.Type: CMD, from the results, right click CMD->Click ‘Run as Administrator’
b. At the Command Prompt, type:chkdsk /r
c. Restart your computer.
When you restart your system, your computer will be scanned for errors and attempts will be made to correct them.
Note: While performing chkdsk on the hard drive if any bad sectors are found on the hard drive when chkdsk tries to repair that sector if any data available on that might be lost.

 

Leave a Reply

Your email address will not be published. Required fields are marked *